Inter Stellar Virtual Library - Images and information on the major components

Inter Stellar - Service/Owners Manual - Cockpit (49 pages - with outer envelope and LDP installation sheet) - SEE UPDATED WIRING DIAGRAMS IN THE SERVICE MANUAL BELOW
Inter Stellar - Service/Owners Manual - Upright (33 pages - with outer envelope and LDP installation sheet) - SEE UPDATED WIRING DIAGRAMS IN THE SERVICE MANUAL BELOW
Inter Stellar - Service Manual / Schematics / Updated Wiring Diagrams (22 pages)
Inter Stellar - DIP Switch Settings

Inter Stellar - ROM Images

 

 

Compatible Laserdisc Player - Pioneer LD-V1000

Pioneer LD-V1000 - Operating Instructions (7 pages)
Pioneer LD-V1000 - Interface Guide (24 pages)
Pioneer LD-V1000 - Service Manual (81 pages)
Pioneer LD-V1000 - Provisional Service Manual (27 pages)
Pioneer LD-V1000 - Cleaning the Optics (3 pages)
Pioneer LD-V1000 - Changing the Laser Tube (3 pages)

Aftermarket Conversion Cards - The original Pioneer LD-V1000 laserdisc player is not natively compatible with any other model for a direct substitution. Various Laserdisc Player Conversion Products have been developed over the years to allow replacement/upgrade of the laserdisc player.

 

 

Interchangeability - Inter Stellar Laser Fantasy can easily be converted to Esh's Aurunmilla by following these steps:

Remove the Inter Stellar main PCB (set of three boards) and the Inter Stellar laserdisc. Esh's Aurunmilla uses the Inter Stellar Sound PCB, the Super Impose PCB, and all the same original wiring. Be careful when hooking up the Esh's PCB to the wiring. Inter Stellar uses two black harness connectors, but only one of them is used by the Esh's PCB. Use the black harness connector that carries most of the wiring (it's a little bigger than the other connector), and it should be inserted with the red wire (+5V) on the right side. Pin 1 of the Esh's connector is GND, and pins 3 & 4 are +5V, so be careful with the orientation. If you are not sure which wire is +5V on the Inter Stellar wiring harness, a DC voltage meter may help. The 6-pin connector on the right side of the Esh's PCB (labeled "CN 1") is the "PCB-generated audio output". It goes into the "CPU IN" audio connector on the Inter Stellar sound board. Finally, connect the Esh's PCB to the LD-V1000 and install the Esh's disc.

There is also a conversion kit that allows Cobra Command to be played in an Inter Stellar cabinet. This kit came with a conversion Cobra Command PCB, conversion ROM set, and a standard Cobra Command laserdisc.

LD-V1000 Boot Switch - A simple inexpensive way to build a switch that issues a play command to the LD-V1000 or LD-V1001. See the LD-V1000 Boot Switch page.

Manufacturer:
Funai/Gakken (USA, 1983)

Emulation and Ports
Virtual Library
Game Info

Message Board
Locations
Chat Room

 

HOME | LASER GAMES | LASER COMMUNITY | TECH CENTER

Questions? Comments? Problems? CONTACT US

dragons-lair-project.com was created by Jeff Kinder & Dave Hallock, 1997 - 2024.
All trademarks and copyrighted materials are property of their respective owners.